Intergrain Nature's Timber Oil
Intergrain Nature's Timber Oil is an oil based timber finish made from 95% sustainable ingredients. The deeply penetrating formula replicates timber's natural defences against ageing, saturating the cells to protect against drying out. Added ingredients give resistance to water, UV and mould. The ingredients in Nature's Timber Oil give a rich, natural oiled finish and highlight the characteristics of popular timber species. Nature's Timber Oil is fast drying, allowing two coats to be applied in one day, and will weather naturally, without risk of cracking, blistering and peeling.
|
Coverage: 6m2/L
|
Recoat: 4hrs
|
Full cure: 7 days
|
|
Clean up: Warm soapy water
|
Sheen: None
|
Sizes: 1L, 4L, 10L
|
-
Natural
-
Dark Oak
Select a colour above to get an idea of how different Intergrain coatings will look
*all colours displayed on this page show 2 coats on merbau timber
|
Areas
Doors, Decking, Fences, Exterior timber, Timber Furniture, Cladding, interior timber
|
|
Substrates
Treated Pine, Kwila, Western Red Cedar
|
|
Locations
Exterior
|
Methods: Intergrain DeckBrush (recommended), spray, lambswool applicator, quality brush
1. Stir thoroughly before and during use with a flat blade stirrer.
2. If project requires more than one can of Nature’s Timber Oil, mix all cans together in one large container to achieve colour uniformity.
3. Apply Nature’s Timber Oil using a brush, lambswool applicator, or spray.
4. When coating large areas, such as decking and weatherboards, coat no more than three boards at a time. Complete an entire length or continue until a natural break such as a window occurs.
5. Wait four hours to dry and apply a second coat. If necessary, sand lightly between coats to remove any raised grain.
6. Wait 30 minutes after the second coat is applied and wipe off excess surface oil. Ensure that excess is wiped before the coating gets tacky.
7. Do not apply to hot surfaces or those in direct sunlight, as doing so may result in difficult application, poor adhesion and blistering.
8. Do not apply in temperatures above 35°C or below 10°C or if rain or dew is expected within four hours of application.
