Intergrain UltraClear Exterior
Intergrain UltraClear Exterior is a tough, clear, marine grade water based timber finish for use on window frames, doors and trims. Incorporating UV absorbers, UltraClear Exterior provides superior protection against the weather including the harmful effects of the sun’s UV radiation. Available in three different sheens, UltraClear Exterior has a low odour and unlike oil based coatings will not yellow. NOTE: Not suitable for walk on areas or broadwalls
|
Coverage: 10m2/L
|
Recoat: 4hrs
|
Full cure: 7 days
|
|
Clean up: Water
|
Sheen: Matt, Satin, Gloss
|
Sizes: 1L, 4L
|
|
Areas
Doors, Window Frames, Trim. Not suitable for walk on areas or broadwalls
|
|
Substrates
Treated Pine & Kwila
|
|
Locations
Exterior
|
Methods: brush, spray, Applicator
1. Stir thoroughly before and during use with a flat blade stirrer.
2. Apply three coats of UltraClear Exterior with a quality brush, pad applicator or spray.
FOUR or more coats will be required in extreme conditions such as full sun exposure, marine environments and in humid areas, and may be required on porous timbers.
3. Apply along the length of the board including exposed edges and end grain.
4. If necessary, sand lightly between coats to remove any raised grain.
5. Keep freshly coated contacting surfaces such as doors and windows ajar for several days if possible. Some tight closing windows may need sealing strips to prevent sticking.
6. Do not apply to hot surfaces or those in direct sunlight, as doing so may result in difficult application.
7. Do not apply in temperatures above 35°C, below 10°C or if rain or dew is expected within four hours of application. Lightly dampening timber before painting will ease application in temperatures
Note: UltraClear™ Exterior is not suitable for heavy wear surfaces (such as decks and walkways), or for exterior broadwall such as cladding and weatherboard. For these areas use UltraDeck® Timber Oil, UltraDeck® Timber Stain, Nature’s TimberOil™, or Heavy Duty.
