Intergrain UltraClear Interior
Intergrain UltraClear Interior is a tough, clear, water based finish for use on interior timber. Incorporating UV absorbers, UltraClear Interior provides greater protection against the colour change of timbers by shielding against the UV rays. UltraClear Interior resists abrasion, water and most household chemicals, is low odour and unlike oil based coatings will not yellow. Easy to apply and fast drying UltraClear Interior allows for several coats to be applied in one day. Available in gloss and satin, UltraClear Interior may be tinted to a selection of colours to create a ‘one step’ stain and varnish.
|
Coverage: 12m2/L
|
Recoat: 3hrs
|
Full cure: 7 days
|
|
Clean up: Water
|
Sheen: Satin, Gloss
|
Sizes: 10L
|
-
Bark
-
Clear
-
Cocoa Bean
-
Dark Oak
-
Driftwood
-
Ebony
-
Icy White
-
Kowhai
-
Macrocarpa
-
Rich Chocolate
-
Rimu
-
Sand
-
White Wash
Select a colour above to get an idea of how different Intergrain coatings will look
*all colours displayed on this page show 2 coats on merbau timber
|
Areas
Doors, Window Frames, Timber Furniture, Interior Timber, Trims, Joinery
|
|
Substrates
Mahogany, Teak, Vic Ash, Macrocarpa, Rimu, Radiata Pine
|
|
Locations
Interior
|
Methods: Brush, Spray
- Stir thoroughly before and during use with a flat blade stirrer. Do not shake or thin. If project requires more than one can of tinted UltraClear Interior, mix all cans together in one large container to ensure colour uniformity.
- Apply a minimum of two generous coats of UltraClear Interior with a quality brush or spray.
- Maintain a wet edge to avoid lap marks and an uneven finish.
- To aid application, soak the brush in water and remove surplus before loading with UltraClear Interior.
- Allow a minimum of three hours drying between coats. Sand lightly with fine grit sandpaper to remove any raised grain.
- If using tinted UltraClear Interior, the colour will become deeper with each application. If desired colour is achieved after one coat, apply untinted UltraClear Interior to complete the required number of coats.
- Do not apply in temperatures above 35°C or below 10°C
