Intergrain UltraFloor
A water based finish that gives a durable, clear finish on interior timber and cork floors. Being water based, UltraFloor emits less VOC’s (Volatile Organic Compounds) into the atmosphere than traditional oil based flooring finishes. This makes UltraFloor safer to use, and much gentler on the environment.
Intergrain UltraFloor is certified under Eco Choice Aotearoa. Eco Choice is a Type 1 eco-labeling company with regulations administered by the New Zealand eco-labeling trust to certify products that adhere to up-to-date standards for environmental compliance in business. This product has undergone independent verification, confirming low VOC levels.
|
Coverage: 10m2/L
|
Recoat: 4hrs
|
Full cure: 7 days
|
|
Clean up: Water
|
Sheen: Gloss & Satin
|
Sizes: 1L, 4L, 10L
|
|
Areas
Parquetry, Cork, Timber floors, Stairs
|
|
Substrates
Mahogany, Teak, Vic Ash, Macrocarpa, Matai, Rimu, Radiata Pine, Tawa
|
|
Locations
Interior
|
Methods: Lambswool applicator, Short nap roller, Quality long bristle brush
- Stir thoroughly before and during use with a flat blade stirrer. Do not thin.
- For a slip resistant surface on stairs and ramps, add Intergrain UltraGrip™ into each coat of UltraFloor Satin. Note: UltraGrip should only be added to UltraFloor Satin as the grip texture will dull a Gloss finish.
- Cut in around edges with a narrow brush or applicator.
- Apply an even, generous coat with a lambswool applicator, short nap roller or quality long bristle brush. Work along the complete length of three to four boards at a time, keeping a wet edge to prevent lapping or join marks. Lay off lightly in the direction of the grain.
- Do not overwork the coating as this will result in a patchy, uneven finish.
- Allow a minimum of four hours to dry. Sand lightly with a fine grit paper to remove any raised grain. Vacuum to remove sanding dust.
- Apply two more coats as above, sanding lightly between coats. More coats may be applied if desired.
- Do not apply in temperatures above 35°C or below 10°C.
